Drinking bowl Mod. 46-VA¾" 24 V, 80 W

Heated drinking bowl with smoothly running tube valve for wall and pipe mounting
Frost-protected down to approx. -15°C. Remaining water in the bowl will not freeze.
With subsequent installation of valve heating (24 V, 5 W, Ref. 101.1405), supplied on demand, is frost-protected down to -35°C!
Drinking bowl made of cast iron, completely enamelled
One drinker is sufficient for 15 – 20 animals
Easy access to installed heating element, which is installed out of reach for the animals between the two bowl parts
Smoothly running tube valve in ¾" brass or in ¾" stainless steel with female connection from top and male connection from bottom
Water flow continuously adjustable from outside by means of a regulation screw
Capacity of the heating element 80 W/24 V – few power consumption
Installation on the wall or on 2" – 3" (60 - 89 mm) pipes
For power supply SUEVIA Transformer 230/24 V is necessary
(for correct choice of transformer see p. 30)
To ensure a frost-free feed pipe, a frost protection heating cable 24 V, 20 W, 2 m (Ref. 101.0861), or a 24 V, 30 W, 3 m (Ref. 101.1863) has to be used. The heating cable should be wrapped around the pipe and connected to the heating element of the drinker in parallel to the power supply cable, coming from the transformer.
If the heating cable is installed on plastic pipes, make sure that this water pipe is suited for warm and cold water. For better heat distribution the water pipe has to be wrapped with an aluminium adhesive tape (Ref. 101.1099) and insulated.